Each driver is assigned a unique key code, which is entered via a hard-wearing and water-proof stainless steel keypad.
Is designed to be used instead of, or alongside, the key switch to prevent unauthorised use of the vehicle and discourage theft.

Each driver is assigned a unique key code or RFID fob, which replaces the key, allowing the driver and truck's activity to be recorded.
The data can then be downloaded to a PC by serial cable and reported on, including usage patterns, impacts, and more.

Each driver is assigned a unique key code or RFID fob, which replaces the key, allowing the driver and truck's activity to be recorded.
The data is automatically synchronised via Wi-fi and can be reported on. Includes a full electronic checklist, and automatic email alerts.

Combines Speed, Tyre and Power functions at a reduced cost compared to the old individual systems, as there is no additional unit to be fitted.
An extremely cost-effective way to increase the service life of your vehicles, and site safety, at the same time!

If low oil pressure or high coolant temperature is detected, an alarm warns the operator, and if the engine is not switched off within 30 seconds it is shut down automatically.
This system is combined with iTEch Power system to prevent excess idling.

Warns the operator that a pre-set lifting pressure limit has been exceeded.
The system is fully adjustable and any level can be set within the limits of the 250 bar pressure transducer fitted within the load cell.

Provides the driver with accurate information about the free space around the vehicle up to 9m, improving safety and the driver's confidence.
This space is divided into three zones, each with its own visual and acoustic signal.

Alerts the operator and those around that the vehicle has suffered an excessive impact, via an alarm and/or flashing beacon.
The alarm can only be de-activated via a key, which would be held by the Site Manager or Supervisor.

Automatically shuts down a truck that is not being used after an adjustable time delay of 1, 2, 4 or 8 minutes.
The device helps to reduce fuel or battery usage and engine wear caused by excessive idle time, preventing premature servicing.

Designed to alert the operator if the seatbelt is disconnected, and can also interrupt the ignition after a time delay.
The only means of resetting the warning is to re-buckle the seatbelt.
Can also be monitored with TDS601.

Monitors the travel speed of any IC forklift truck and indicates when a set speed has been exceeded with an alarm and/or flashing beacon.
The system does not govern the engine, and the limit can be set to suit the specific application requirements.

Limits the travel speed of a forklift truck, by detecting that the truck is moving and then applying a throttle restriction.
When the truck slows down, the limit is removed to allow full power for lift hydraulics.
Available for cable and electronic throttles.

Automatically enforces safe speeds in designated areas, whilst allowing higher speed in lower risk areas, which must be manually engaged.
In the case of a fault or tampering, the system will default to low speed, and high speed will be disabled.

Offers improved visibility to the operator from the standard driving position.
The camera is fitted on the vehicle to focus on the area of sight required, with the live video shown on an in-cab monitor.

A vehicle-mounted camera and recording unit enables management to review incidents that have occurred in the work place.
Recorded footage from shortly before the impact to shortly after is automatically stored for later download by USB.

Alerts pedestrians of an approaching forklift truck with a brightly-coloured spotlight on the floor.
Ideally suited to trucks operating in warehouse aisles, and where pedestrians and forklift trucks are required to operate safely alongside each other.

Uses Active RFID technology to detect personnel within a pre-determined safety zone around vehicles, machines and hazardous areas.
The system provides an audible and visual warning to vehicle operators when a transponder is detected entering the safety zone.